Service Bulletin
Service Bulletin JBL2000-01 Rev3 - October 2001 Warranty labor rate: MINOR repair
To: All JBL Service Centers
Models: PSW-D110, DPS-10, ARC SUB8, ARC SUB10, DS-10
Subject: Failure of C6
In the event you receive a JBL subwoofer corresponding to one of the above models with the
complaint ?no output? and capacitor C6 (10uf 50v NPE) is damaged in the amplifier:
Order kit JBL part# 30721 and replace the following included parts:
C6 - (10uf 100v NPE cap) C24 - (100nF 50v cap)
R46 - (47& 1/4W resistor) R23 - (20k & 1/2W resistor - only on models PSW-D110, DPS-10)
50K Crossover potentiometer - (replace only if necessary on models PSW-D110, DPS-10 - outer nut
should be finger tight plus 1/8 turn with tool to avoid damage)
ARC SUB8, ARC SUB10, DS-10 PSW-D110, DPS-10
General reference for location only; not all parts or designators may conform exactly to these drawings.
FOLLOWING THE REPAIR:
Follow instructions included in bulletin #JBL9903 rev1.
IMPORTANT SERVICE NOTES: When testing the PSW-D, ARCSUB, or Decade Series amplifier, a load must always
be connected to the output terminals, whether the woofer, or a 4 to 8 ohm resistive load.
All AC powered test instruments (meters, oscilloscopes, etc.) must have a floating ground, i.e. be connected to an
isolation transformer.
MODELS SERIAL NUMBER STATUS ACTION
120/230V
PSW-D110 157456 and above are
factory modified Replace C6,R23, C24, R46
DPS-10 All serial numbers Replace if damaged with
ARC SUB8 JBL part# 30721
affected
ARC SUB10 DS-10
15 |